How to Replace Flash for Canon PowerShot SD750 Camera

by Dou
Published on: August 4, 2011
Comments: 1 Comment

I often saw users asked online for about how to replace Canon PowerShot SD750 battery camera flash. As the flash has its life for times, now you can replace the flash step by step as show in this post, wish IBM ThinkPad T60 battery helpful for you.

Step 1:

You need a small four-arm screwdriver to remove the screws MINOLTA NP-200 battery.

There are 2 screws at the side of the camera as shown in the following image.

remove screw

remove screw

And there are 2 screws at the bottom of the camera as shown in the following image.

remove screw

remove screw

At the other side there are also 2 screws. ThinkPad T60 battery

remove screw

remove screw

Remover all of these screws and place them careful. Some parts of the camera may full off after removing these screws.

Step 2:

Try to remove the plastic subsection of the cover at the side of the camera.

side cover

side cover

Then both the back cover and the front cover will be loose and you can remove them NP-200.

remove cover

remove cover

Step 3: HP Pavilion dv6000 battery

Remove the screw in the following image and remove the A/V digital port.

remove screw

remove screw

Step 4:

Remove the screw holding the LCD screen,

screen holder

screen holder

and then remove the LCD

screen

screen

Note, there is a flat cable link the screen to the camera.

note

note

Step 5:

Remove the plastic and rubber circular button and the part under it.

button

button

Step 6:

Remove the flat cable as following.

ribbon

ribbon

Step7

There are many part linked by the flat cables.

connector

connector

left parts

left parts

At last, you can remove the flash and change it to a new one.

flash

flash



Welcome , today is Friday May 18, 2012