When I turn on my Sony Cyber-shot DSC-W310 camera it says enter, shot out and shrink back, I get a message saying the pronunciation of and turn the power off and on again. I did it again and again, still will not work.
The problem is that lens is stuck. There are some DIY solutions, you can try, but the probability is not 100%, you must have it by professional fixed. The risk in their use, as it may further damage the camera.
First, try to connect the AC power adapter or USB cable.
Hold on give it a try and the camera shutter button switch EASYSHARE ONE Battery.
Lens, if academics did not align on some of the lens or not concentric and then try to twist it (hold down the camera lens).
When you try to push or pull the lens gently, it extends, but this is risky, because it may cause the lens barrel, sliding out of its guidance system.
Another way to do this, the lens should be put on a hard surface, and then powering it. Be sure to use a soft cloth or something similar, to not scratch your shot or shell. Push camera lens up and down several times, sometimes resistance is small, is provided by the camera enough to let things go.
Try to hit the camera body near the lens by the soft tissue of your palms.
In addition, I would like to take this camera repair center assessment, its maintenance cost will be higher, rather than replacing the camera.
If still under warranty, I suggest you put it in before you try these steps, any delete of any non-brand batteries or accessories shop about camera warranty maintenance of really critical and non-branded accessories.
My Sony Cyber-shot DSC-W310 camera work very well for a year, and when I opened the black screen to access it, small yellow lights continue to Flash, zoom lens kept in and out, but cannot gain access to it, and conversely, a screen zoom power, and then open. The DSC-W310 battery is fully charged. When I try to close the lens back and forth constantly enlarged several times until it finally closed. Making such a person says, has not changed. What to do next?
I have exactly the same problem, so here is some of its solution. Remove the battery, once the dead battery, driving at least 20 seconds the power button, this will launch for power consumption reduction software, introduces the battery, and follow the program starts. Let the camera battery charge and discharge, so that this problem should be gone until you can get another Rebel Xsi battery, because this is the causes of the conflict.
My Sony Cyber-shot DSC-W310 digital camera lens will not be fully open.
It may have had an impact or gravel/dirt may have to it, try a joint Q Tip drop of oil and lubricants with the protective lens cover gently.
My Sony Cyber-shot DSC-W310 doesn’t work at all under zoom mode. Are my settings are not correct? I search/read this manual. Haven’t comments directly to the problem. It is used to determine one week ago. I didn’t give it up, but I may not have the correct settings or change things.
The focus may not work properly if:
Mode or landscape mode, or in the evening Fireworks shooting mode is selected, select a still image.
The focus preset feature is selected. Select the auto-focus mode with DSC-T1 battery.
Attempts to initialize the camera are as follows (initially the camera settings will be reset to factory settings, including the date and time, it will not delete any data stored in the camera. ）：
Press the home button on the camera. Then, select the setting-> “main settings”-> main settings 1-”initialize”-> OK.
If the problem still exist power reset attempts to remove the battery from the camera and inserting after 1 minute, its camera.
If the problem persists, then services may need to be addressed.
Not logged in